Under normal conditions, we recommend replacing the blade after approximately: 300 cuts However, this is only a recommended value. The actual blade lifespan may increase or decre...
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction. The blade-down action is controlled by the Y-axis motor signal fro...
"The rubber cutting mat strip located beneath the blade serves to prevent blade wear and extend the blade’s service life. However, after prolonged use, the surface of the mat strip...
"The default parameters of the screen protector cutting machine — blade holder scale 5 and cutting pressure 300g — are suitable for most materials, including HD clear film. If the...
"The recommended cutting parameters for UV materials on the screen protector cutting machine are: Blade holder scale: 6, Cutting pressure: 380. If the machine cannot cut properl...
"If the machine is unable to cut screen protector materials properly, please first try the following steps: Replace the blade and blade holder with new ones. Set the cutting pre...
It is generally recommended to replace the blade after around 300 cuts. The actual replacement frequency may vary depending on material type and usage. If cutting quality...
The correct cutting parameters depend on the materials being used. Here are some recommended settings for common materials: Material | Back Film | Four Layer Soft Film | Explosion-...
This issue is usually caused by the rollers not gripping the material properly, allowing it to shift during cutting. Please check the following: Ensure all rollers are positioned...
If you encounter problems while configuring the machine, you can try using the following default settings, which work for most materials: Recommended Default Settings Speed: 20...
"The recommended cutting parameters for back films are: Material Size: 180mm width × 120mm height Pressure: 300 Blade Holder Scale: 5 Speed: 200 These settings are suit...
Installing a UV screen protector is different from applying regular screen protector materials. UV protectors require an additional curing step to harden the surface. Steps &...
"The intelligent film cutting machine has two belts: One is used to control the left-right movement of the carriage https://osscdn.mietubl.com/images/X-axis-belt.jpg The othe...
This issue is usually caused by the fixing screws at the back of the machine that secure the carriage during shipping not being removed. Please check if the fixing screws at the b...
"If the cutting machine stops halfway, it is usually due to incorrect material size or parameter settings. When the cutting carriage reaches the edge, it triggers the edge sensor,...
In most cases, it is recommended to keep the cutting speed at the default value of 200. This setting is suitable for most cutting materials. The recommended blade pressure is: 30...
"In the MTB-CUT M188 screen protector cutting machine, the rubber strip at the bottom of the cutting module is designed to protect the cutting blade and extend the lifespan of both...
Yes, the screen protector machine can cut PET material. However, you may need to adjust the machine settings, and keep in mind that PET material is more likely to wear out the cutt...
Yes, we offer a one-year warranty for our screen protector machine. Skilled technicians will provide free product consultation services. Please note that consumables like the cutti...
No, the machine uses a blade to cut, which makes it safe, quiet, and pollution-free ideal for use in locations like shopping malls or at home.
