Mietubl
Mietubl Cutting Machine Knowledge Base

What to do if the device displays "Reconnect" after startup

Last updated Nov 22, 2025
M
Mietubl Team
cutting machine hardware issue mainboard replacement device troubleshooting reconnect error firmware upgrade startup issue error message system firmware 180t
If the 180T screen protector cutting machine displays a “Reconnection” message after startup, it is likely that there is an issue with the system firmware.
You can resolve this by upgrading the firmware using the following steps.

If the issue persists after the firmware upgrade, it may indicate a problem with the mainboard.
In this case, the mainboard will need to be replaced.

Was this article helpful?

Your feedback helps us improve the knowledge base.

Previous
My machine is not loading anything, even with the internet working
 Next
How can I connect screen protector machine with laptop