MTB-CUT 180T

Why it cuts half and then leaves

"If the cutting machine stops halfway, it is usually due to incorrect material size or parameter settings. When the cutting carriage reaches the edge, it triggers the edge sensor,...

Nov 22, 2025

MTB-CUT 180T

Why does it throw some slices out halfway?

This issue is usually caused by a mismatch between the material size settings and the template being used. When cutting full back film, the cutting area is larger than standard te...

MTB-CUT 180T

How to Correct Car Limit Malfunction

"If the cutting Car fails to stop properly when reaching the edge and produces a loud noise, it is likely due to an error in the Car’s limit positioning. You can replace specific p...

Nov 22, 2025

MTB-CUT M188

How to Replace the Limit Switch

"If the cutting Car does not stop automatically when it moves to either side and produces a loud noise, it may be due to a malfunctioning limit switch, which prevents the cutting C...

Nov 22, 2025

MTB-CUT M688/M288

Touch screen not responding

If your touch screen is not responding properly, please check the following: 1. Confirm you are using the original power adapter The original adapter should be 24V / 2.7A. Usi...