This issue is usually caused by the Blade Holder scale being set too high. Please try to reduce the Blade Holder scale setting. Important Note Pay attention to the blade exposur...
"When replacing the blade, simply press the top of the blade holder to remove the old blade and insert a new one. Please refer to the video below for detailed instructions on how t...
If the film is being damaged during cutting, the Blade Holder Scale may be set too high. Please try reducing the Blade Holder Scale. 👉 Recommended Blade Holder Scale: 5 Under n...
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction. The blade-down action is controlled by the Y-axis motor signal fro...
The Blade Holder Scale depends on the thickness of the material. For most TPU screen protector materials, the following settings are recommended: Blade Size: 5 Pressure: 300 &n...
The Blade Holder Scale depends on the thickness of the material. For most Back Film materials, the recommended settings are: Blade Size: 4 Pressure: 300 These settings...
Laptop screen protectors have a much longer cutting path, and during long-distance cutting, the material may experience slight deviation due to blade pressure. This can cause inacc...
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction. The blade-down action is controlled by the Y-axis motor signal fro...
"The rubber cutting mat strip located beneath the blade serves to prevent blade wear and extend the blade’s service life. However, after prolonged use, the surface of the mat strip...
When you first receive the machine, you must remove the transport-locking screw located on the back of the device to prevent damage to the blade carriage. During normal daily us...
"The default parameters of the screen protector cutting machine — blade holder scale 5 and cutting pressure 300g — are suitable for most materials, including HD clear film. If the...
"The recommended cutting parameters for UV materials on the screen protector cutting machine are: Blade holder scale: 6, Cutting pressure: 380. If the machine cannot cut properl...
"If the machine is unable to cut screen protector materials properly, please first try the following steps: Replace the blade and blade holder with new ones. Set the cutting pre...
This issue is usually caused by incorrect roller positioning, resulting in uneven pressure on the material and inconsistent cutting sizes. To adjust the roller position, press dow...
This issue is usually caused by incorrect roller positioning, resulting in uneven pressure on the material and inconsistent cutting sizes. To adjust the roller position, press dow...
"If the tablet screen protector is not cutting well, it is usually because the roller is not providing enough pressure. You can try the following solutions: Lift the gear at the ba...
It is generally recommended to replace the blade after around 300 cuts. The actual replacement frequency may vary depending on material type and usage. If cutting quality...
Please first confirm the specific issue you are facing: 1. If the blade holder does not go down during cutting This is usually caused by a mainboard malfunction. In this case, t...
The correct cutting parameters depend on the materials being used. Here are some recommended settings for common materials: Material | Back Film | Four Layer Soft Film | Explosion-...
If you encounter problems while configuring the machine, you can try using the following default settings, which work for most materials: Recommended Default Settings Speed: 20...
