Showing 69 results
for
"replace sensor"
MTB-CUT M188
"The silicone pad is one of the few parts in the MTB-CUT M288 intelligent film cutting and pasting machine that requires replacement.
It is essential for the proper installation of...
MTB-CUT 180T
1. Check whether the Wi-Fi module is working
Open the Wi-Fi list page on your machine and confirm:
Whether the machine can scan and display the Wi-Fi networks around you;
Whethe...
MTB-CUT 180T
When you first receive the machine, you must remove the transport-locking screw located on the back of the device to prevent damage to the blade carriage.
During normal daily us...
MTB-CUT M688/M288
The “Reconnection” message means that the screen cannot establish a proper connection with the mainboard.
This issue is typically caused by a loose or faulty screen-to...
MTB-CUT 180T
If the machine displays a “Time Out” error during film cutting, please follow the steps below:
1. Check whether the motherboard is connected
On the machine, go to:...
MTB-CUT 180T
If the machine is showing “Failed to query the hardware version of the machine”, the machine’s mainboard may be faulty.
In this case, the mainboard may...
MTB-CUT 180T
According to your description, this issue is usually caused by a short circuit on the motherboard or a motherboard failure. When the motherboard fails to complete the self-test, th...
MTB-CUT 180T
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction.
The blade-down action is controlled by the Y-axis motor signal fro...
MTB-CUT M688/M288
If your touch screen is not responding properly, please check the following:
1. Confirm you are using the original power adapter
The original adapter should be 24V / 2.7A.
Usi...
Showing 61
to 69
of 69 results
