Showing 9 results
for
"housing damage"
MTB-CUT 180T
"The machine features an independent housing design.
In the event of housing damage, you can replace the machine’s outer shell separately without needing to replace the entire unit...
MTB-CUT 180T
This issue is usually caused by the Blade Holder scale being set too high.
Please try to reduce the Blade Holder scale setting.
Important Note
Pay attention to the blade exposur...
MTB-CUT 180T
Under normal conditions, we recommend replacing the blade after approximately: 300 cuts
However, this is only a recommended value.
The actual blade lifespan may increase or decre...
MTB-CUT 180T
"English Version
If you notice white edges when applying a screen protector using the MTB-CUT M288, the issue may be caused by the following reasons:
Template too large
It’s re...
MTB-CUT 180T
For most cutting tasks, we recommend using the machine’s default settings:
👉 Cutting Speed: 200
👉 Blade Pressure: 300
These settings are suitable for the majority of scr...
MTB-CUT 180T
If the film is being damaged during cutting, the Blade Holder Scale may be set too high.
Please try reducing the Blade Holder Scale.
👉 Recommended Blade Holder Scale: 5
Under n...
MTB-CUT M688/M288
"To update the firmware on the M288 for fixing issues like UV film white edges, follow these steps carefully:
Connect to a stable network
Ensure the M288 is connected to a reliabl...
MTB-CUT 180T
When you first receive the machine, you must remove the transport-locking screw located on the back of the device to prevent damage to the blade carriage.
During normal daily us...
MTB-CUT M688/M288
If your touch screen is not responding properly, please check the following:
1. Confirm you are using the original power adapter
The original adapter should be 24V / 2.7A.
Usi...
Showing 1
to 9
of 9 results
Previous
Next
