This issue is usually caused by a mismatch between the material size settings and the template being used. When cutting full back film, the cutting area is larger than standard te...
"The parameter settings of a screen protector cutting machine mainly depend on the physical properties of the material. The thicker the material, the higher the blade holder scale...
"The default parameters of the screen protector cutting machine — blade holder scale 5 and cutting pressure 300g — are suitable for most materials, including HD clear film. If the...
"The recommended cutting parameters for UV materials on the screen protector cutting machine are: Blade holder scale: 6, Cutting pressure: 380. If the machine cannot cut properl...
In most cases, it is recommended to keep the cutting speed at the default value of 200. This setting is suitable for most cutting materials. The recommended blade pressure is: 30...
"If the machine is unable to cut screen protector materials properly, please first try the following steps: Replace the blade and blade holder with new ones. Set the cutting pre...
"In the MTB-CUT M188 screen protector cutting machine, the rubber strip at the bottom of the cutting module is designed to protect the cutting blade and extend the lifespan of both...
When the machine beeps with a repeated “bip bip” sound and fails to start cutting, it usually means that the X-axis or Y-axis cannot operate normally. Common causes include a stuc...
"The recommended cutting parameters for back films are: Material Size: 180mm width × 120mm height Pressure: 300 Blade Holder Scale: 5 Speed: 200 These settings are suit...
Large-size screen protectors such as iPad and laptop films have longer cutting paths. During long-distance cutting, the material may slightly shift due to the blade pressure, whic...
The material size setting depends on the actual material you are using. By default, the machine is set to: 180 mm (width) × 120 mm (height) Please pay attention to the o...
When cutting full-screen back films, please disable the "Cut Center" option on the cutting page. Additionally, ensure that the material size is set to 180mm x 120mm. Since the ful...
"If the cut model from the machine is inaccurate, the possible reasons include: Incorrect model selection Make sure the selected cutting model in the machine matches the actual de...
If you discover a size cutting problem during cutting, please send us the following information: The phone’s System Information page The corresponding cutting template/mode...
"If the cutting machine stops halfway, it is usually due to incorrect material size or parameter settings. When the cutting carriage reaches the edge, it triggers the edge sensor,...
For the Mietubl MTB-CUT 180T screen protector cutting machine, the maximum supported cutting size is: 16 inches
"Cutting misalignment is usually caused by: Center Cutting Not Enabled: Make sure the “Center Cutting” option is enabled on the cutting page so the machine automatically positions...
"This is caused by an incorrect ""Material Size"" setting. For custom cuts, you must first define the dimensions of the film you are using (e.g., 300x200 mm). The machine uses this...
"Solution: Mietubl’s screen protector cutting machines come with a built-in data editing function, which allows you to modify and resize existing templates according to your requir...
The screen protector machine will automatically find the middle cutting position according to the material size setting. Adjust the material size setting to change the cutting rang...
