Please open the machine’s WiFi list and check whether available WiFi networks can be detected normally. If the machine cannot detect or display WiFi networks, the machine’s networ...
"If the cutting Car fails to stop properly when reaching the edge and produces a loud noise, it is likely due to an error in the Car’s limit positioning. You can replace specific p...
"If the MTB-CUT M288 intelligent film cutting and pasting machine displays a ""Reconnection"" message at startup or if the cutting Car fails to cut properly, the mainboard may be f...
"The MTB-CUT M288 intelligent film cutting and pasting machine uses a modular fixture design. If the fixture is unable to properly hold the phone, you can quickly replace it using...
"The silicone pad is one of the few parts in the MTB-CUT M288 intelligent film cutting and pasting machine that requires replacement. It is essential for the proper installation of...
"White edges when applying film with the MTB-CUT M288 may be caused by the following reasons: Firmware issue – Please ensure your firmware version is V25.0431. https://osscdn.mi...
If your MTB-CUT M188 displays “Time Out” after powering on, it is usually caused by an abnormal serial communication between the screen and the mainboard. This situati...
"If the MTB-CUT M288 intelligent film cutting and pasting machine displays a ""Reconnection"" message at startup or if the cutting Car fails to cut properly, the mainboard may be f...
"The MTB-CUT M288 intelligent film cutting and pasting machine uses a modular fixture design. If the fixture is unable to properly hold the phone, you can quickly replace it using...
"The silicone pad is one of the few parts in the MTB-CUT M288 intelligent film cutting and pasting machine that requires replacement. It is essential for the proper installation of...
1. Check whether the Wi-Fi module is working Open the Wi-Fi list page on your machine and confirm: Whether the machine can scan and display the Wi-Fi networks around you; Whethe...
The “Reconnection” message means that the screen cannot establish a proper connection with the mainboard. This issue is typically caused by a loose or faulty screen-to...
If the machine displays a “Time Out” error during film cutting, please follow the steps below: 1. Check whether the motherboard is connected On the machine, go to:...
If the machine is showing “Failed to query the hardware version of the machine”, the machine’s mainboard may be faulty. In this case, the mainboard may...
According to your description, this issue is usually caused by a short circuit on the motherboard or a motherboard failure. When the motherboard fails to complete the self-test, th...
If your touch screen is not responding properly, please check the following: 1. Confirm you are using the original power adapter The original adapter should be 24V / 2.7A. Usi...
