The blade size (blade holder scale) should be adjusted based on the thickness and hardness of the film material. Thicker or harder materials require a higher blade size, while thi...
"Prolonged use of excessively high blade holder settings and cutting pressure may lead to a decline in the precision of the blade holder, resulting in the inability to properly cut...
"The intelligent film cutting machine is easy to set up. The standard settings include cutting pressure, cutting speed, blade holder scale, and material size. Material size mainl...
If you want to improve cutting results, please follow these tips: Check Wheel Position Make sure all pinch wheels firmly press on the cutting material, and their position is on t...
"When the film bulges during cutting, it is usually caused by the following reasons: Blade holder depth set too high – Excessive cutting depth can cause uneven stress on the materi...
"The intelligent film cutting machine is easy to set up. The standard settings include cutting pressure, cutting speed, blade holder scale, and material size. Material size main...
"When replacing the blade, simply press the top of the blade holder to remove the old blade and insert a new one. Please refer to the video below for detailed instructions on how t...
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction. The blade-down action is controlled by the Y-axis motor signal fro...
"The intelligent film cutting machine is easy to set up. The standard settings include cutting pressure, cutting speed, blade holder scale, and material size. Material size main...
"The rubber cutting mat strip located beneath the blade serves to prevent blade wear and extend the blade’s service life. However, after prolonged use, the surface of the mat strip...
"If the Car moves after you initiate cutting, but the blade holder does not drop, this issue may be caused by one of the following reasons: Insufficient power supply – Please verif...
When you first receive the machine, you must remove the transport-locking screw located on the back of the device to prevent damage to the blade carriage. During normal daily us...
"The material size setting depends on the type of material you are using. Mietubl's standard material size is 180mm (width) x 120mm (height). You can configure your machine accord...
"When cutting back films, you need to consider both the pattern position and the cutting range. You can adjust these by setting the material size and enabling or disabling center c...
The default paper size setting for mobile phone screen protectors is 180mm width × 120mm height. This size is suitable for most cutting needs, so you can generally keep this settin...
The MTB-CUT 180T screen protector cutting machine supports a maximum cutting width of 228 mm, which corresponds to screen protectors up to approximately 16 inches in size. Notes:...
This issue is usually caused by a mismatch between the material size settings and the template being used. When cutting full back film, the cutting area is larger than standard te...
"Here are some default setting ：material size is 180mm width × 120mm height. Cutting pressure: 300 Cutting speed: 200 Blade holder scale: 5 These default settings are sui...
"This can be caused by several issues: - Incorrect Power Supply: Ensure you are using the original power adapter. An incorrect adapter can cause insufficient power. - Blade Pressu...
"This issue can be caused by several reasons: Low Cutting Pressure Check your cutting pressure settings. If the pressure is too low, the blade holder won’t drop enough to tou...
