Showing 15 results
for
"malfunction"
MTB-CUT 180T
"Communication failure with the machine is typically caused by network issues or a mainboard malfunction.
When encountering this problem, please try the following steps:
Reconne...
MTB-CUT 180T
"If the cutting process cannot start, please follow these steps to troubleshoot:
Restart the machine: Power off and then restart the device.
Check carriage reset: When the machi...
MTB-CUT 180T
"By default, the Mietubl screen protector cutting machine does not support direct PC connection.
The machine runs on an independent embedded operating system, and all templates and...
MTB-CUT 180T
"By default, the Mietubl screen protector cutting machine does not support direct PC or laptop connection.
The machine runs on an independent embedded operating system, and all tem...
MTB-CUT 180T
"If the cutting Car fails to stop properly when reaching the edge and produces a loud noise, it is likely due to an error in the Car’s limit positioning.
You can replace specific p...
MTB-CUT M288
"If the MTB-CUT M288 intelligent film cutting and pasting machine fails to automatically secure the screen protector or if the vacuum pump does not start, it may indicate a vacuum...
MTB-CUT M188
A “Time Out” message usually means that there is a communication failure between the screen and the mainboard. This can be caused by:
Loose or Damaged Screen Cable
Op...
MTB-CUT M188
"If the MTB-CUT M288 intelligent film cutting and pasting machine fails to automatically secure the screen protector or if the vacuum pump does not start, it may indicate a vacuum...
MTB-CUT M288
If the MTB-CUT M288 triggers an alarm during the installation process—especially when installing on iPhone models—please don't worry.
This happens because the silicone...
MTB-CUT 180T
If the machine displays a “Time Out” error during film cutting, please follow the steps below:
1. Check whether the motherboard is connected
On the machine, go to:...
MTB-CUT 180T
This error is usually caused by a mainboard malfunction.
To fix the issue, please follow these steps:
Replace the mainboard following the instructional video.
Before replacing...
MTB-CUT 180T
Please first confirm the specific issue you are facing:
1. If the blade holder does not go down during cutting
This is usually caused by a mainboard malfunction.
In this case, t...
MTB-CUT 180T
If the blade does not drop properly during cutting, this issue is most likely caused by a mainboard malfunction.
The blade-down action is controlled by the Y-axis motor signal fro...
MTB-CUT 180T
"If you are unable to start the machine and the power switch does not light up when pressed, it is likely that the switch is malfunctioning.
This video provides a step-by-step guid...
MTB-CUT M188
"If the cutting Car does not stop automatically when it moves to either side and produces a loud noise, it may be due to a malfunctioning limit switch, which prevents the cutting C...
Showing 1
to 15
of 15 results
Previous
Next
