Showing 243 results
for
"cutting methods"
MTB-CUT 180T
"When cutting back films, you need to consider both the pattern position and the cutting range. You can adjust these by setting the material size and enabling or disabling center c...
MTB-CUT 180T
Large-size screen protectors such as iPad and laptop films have longer cutting paths.
During long-distance cutting, the material may slightly shift due to the blade pressure, whic...
MTB-CUT 180T
Laptop screen protectors have a much longer cutting path, and during long-distance cutting, the material may experience slight deviation due to blade pressure. This can cause inacc...
MTB-CUT 180T
"By default, the Mietubl screen protector cutting machine does not support direct PC connection.
The machine runs on an independent embedded operating system, and all templates and...
MTB-CUT 180T
"By default, the Mietubl screen protector cutting machine does not support direct PC or laptop connection.
The machine runs on an independent embedded operating system, and all tem...
MTB-CUT 180T
If the machine is vibrating abnormally, please check the following two points:
1. Check the transportation screw
If this is a new machine, please make sure the screw on the back...
MTB-CUT 180T
"Error 1002 indicates a serial communication error within the machine.
If you encounter this issue, please try the following steps:
Reconnect to Wi-Fi and restart the device...
MTB-CUT 180T
"If your machine stays in the “Status Checking” state for a long time, it may be caused by network delays or communication errors. Please try the following steps:
Restart the machi...
MTB-CUT 180T
If the cut size is slightly larger, you can try the following methods:
Choose templates labeled “with case”, which are slightly smaller to fit phone cases
Use the bui...
MTB-CUT 180T
The cutting speed does not have a major impact on most cutting tasks.
In general:
👉 200 is the recommended default cutting speed.
You only need to reduce the cutting speed when...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size main...
MTB-CUT 180T
Center Cutting is a function that positions the cutting area exactly in the center of the material.
The cutting position is calculated based on the width and height values you ent...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size mainl...
MTB-CUT 180T
This issue is usually caused by a mismatch between the material size settings and the template being used.
When cutting full back film, the cutting area is larger than standard te...
MTB-CUT 180T
This issue is usually caused by a mismatch between the material size settings and the template being used.
When cutting full back film, the cutting area is larger than standard te...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size main...
MTB-CUT 180T
"When the film bulges during cutting, it is usually caused by the following reasons:
Blade holder depth set too high – Excessive cutting depth can cause uneven stress on the materi...
MTB-CUT 180T
If you want to improve cutting results, please follow these tips:
Check Wheel Position
Make sure all pinch wheels firmly press on the cutting material, and their position is on t...
MTB-CUT 180T
"The rubber cutting mat strip located beneath the blade serves to prevent blade wear and extend the blade’s service life.
However, after prolonged use, the surface of the mat strip...
MTB-CUT 180T
"If the machine is unable to cut screen protector materials properly, please first try the following steps:
Replace the blade and blade holder with new ones.
Set the cutting pre...
Showing 1
to 20
of 243 results
