When you first receive the machine, you must remove the transport-locking screw located on the back of the device to prevent damage to the blade carriage. During normal daily us...
"Prolonged use of excessively high blade holder settings and cutting pressure may lead to a decline in the precision of the blade holder, resulting in the inability to properly cut...
When the machine beeps with a repeated “bip bip” sound and fails to start cutting, it usually means that the X-axis or Y-axis cannot operate normally. Common causes include a stuc...
Please follow the blade replacement instructions to correctly insert or replace the blade in the Blade Holder. If you are unable to press the Blade Holder, the blade may be stuck...
This issue is usually caused by the cutting carriage becoming loose from the guide rail. When the carriage is not firmly fixed, the blade cannot follow an accurate circular path, r...
This issue is usually caused by the cutting carriage becoming loose from the guide rail. When the carriage is not firmly fixed, the blade cannot follow an accurate circular path, r...
If you want to improve cutting results, please follow these tips: Check Wheel Position Make sure all pinch wheels firmly press on the cutting material, and their position is on t...
If the film is being damaged during cutting, the Blade Holder Scale may be set too high. Please try reducing the Blade Holder Scale. 👉 Recommended Blade Holder Scale: 5 Under n...
If the circle cut is not perfect, the issue is usually caused by a loose cutting carriage, which makes the cutting path unstable and results in an imperfect circle. Please follo...
"A knocking sound from the machine can be caused by the following reasons and can be resolved as follows: Transport screws not removed (for new machines) New machines are shippe...
Please first confirm the specific issue you are facing: 1. If the blade holder does not go down during cutting This is usually caused by a mainboard malfunction. In this case, t...
"If the Car moves after you initiate cutting, but the blade holder does not drop, this issue may be caused by one of the following reasons: Insufficient power supply – Please verif...
"When the film bulges during cutting, it is usually caused by the following reasons: Blade holder depth set too high – Excessive cutting depth can cause uneven stress on the materi...
For most cutting tasks, we recommend using the machine’s default settings: 👉 Cutting Speed: 200 👉 Blade Pressure: 300 These settings are suitable for the majority of scr...
If the main holder (blade carriage holder) becomes loose and you need to press it by hand for proper cutting, this means the part is worn out or has lost stability. The cutting ho...
The blade size (blade holder scale) should be adjusted based on the thickness and hardness of the film material. Thicker or harder materials require a higher blade size, while thi...
"The intelligent film cutting machine is easy to set up. The standard settings include cutting pressure, cutting speed, blade holder scale, and material size. Material size mainl...
This issue is usually caused by a loose carriage, resulting in unstable cutting paths and improper round cutting. Please follow these steps: Refer to the instruction video and re...
If the machine is vibrating abnormally, please check the following two points: 1. Check the transportation screw If this is a new machine, please make sure the screw on the back...
If the camera lens cutout appears oval-shaped, it is likely caused by a loose carriage. Please follow these steps: Refer to the instructional video to refit the carriage onto the...
