Showing 241 results
for
"cutting position"
MTB-CUT 180T
"If the cutting process cannot start, please follow these steps to troubleshoot:
Restart the machine: Power off and then restart the device.
Check carriage reset: When the machi...
MTB-CUT 180T
There are three possible causes for this error:
1. The template width exceeds the maximum supported size
The maximum cutting width of the screen protector machine is 228 mm.
If...
MTB-CUT M288
There are three possible causes for this error:
1. The template width exceeds the maximum supported size
The maximum cutting width of the screen protector machine is 228 mm.
If...
MTB-CUT 180T
"If the tablet screen protector is not cutting well, it is usually because the roller is not providing enough pressure. You can try the following solutions:
Lift the gear at the ba...
MTB-CUT 180T
"If the machine is continuously beeping and not working properly, please try the following steps:
Force Restart: Press and hold the power button for 20 seconds to force the machine...
MTB-CUT 180T
"The continuous running of the motor may be caused by the following reasons:
Poor motor wiring connection: Check if the motor wiring is secure. If there is any looseness or poor co...
MTB-CUT 180T
The cutting speed does not have a major impact on most cutting tasks.
In general:
👉 200 is the recommended default cutting speed.
You only need to reduce the cutting speed when...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size main...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size mainl...
MTB-CUT 180T
This issue is usually caused by a mismatch between the material size settings and the template being used.
When cutting full back film, the cutting area is larger than standard te...
MTB-CUT 180T
This issue is usually caused by a mismatch between the material size settings and the template being used.
When cutting full back film, the cutting area is larger than standard te...
MTB-CUT 180T
"The intelligent film cutting machine is easy to set up.
The standard settings include cutting pressure, cutting speed, blade holder scale, and material size.
Material size main...
MTB-CUT 180T
"When the film bulges during cutting, it is usually caused by the following reasons:
Blade holder depth set too high – Excessive cutting depth can cause uneven stress on the materi...
MTB-CUT 180T
"The rubber cutting mat strip located beneath the blade serves to prevent blade wear and extend the blade’s service life.
However, after prolonged use, the surface of the mat strip...
MTB-CUT 180T
"If the machine is unable to cut screen protector materials properly, please first try the following steps:
Replace the blade and blade holder with new ones.
Set the cutting pre...
MTB-CUT M288
You can follow the video tutorial provided below to operate the MTB-CUT M288 intelligent cutting and pasting machine.
The video demonstrates all the required steps for proper cutt...
MTB-CUT 180T
If you discover a size cutting problem during cutting, please send us the following information:
The phone’s System Information page
The corresponding cutting template/mode...
MTB-CUT 180T
"Cutting misalignment is usually caused by:
Center Cutting Not Enabled: Make sure the “Center Cutting” option is enabled on the cutting page so the machine automatically positions...
MTB-CUT 180T
When you say “wrong cutting”, we need more specific information to provide the correct solution.
Please confirm whether you selected the correct phone model/template...
MTB-CUT 180T
"If the Car moves after you initiate cutting, but the blade holder does not drop, this issue may be caused by one of the following reasons:
Insufficient power supply – Please verif...
Showing 21
to 40
of 241 results
