Showing 13 results
for
"disable"
MTB-CUT 180T
When cutting full-screen back films, please disable the "Cut Center" option on the cutting page.
Additionally, ensure that the material size is set to 180mm x 120mm.
Since the ful...
MTB-CUT 180T
"The material size setting depends on the type of material you are using.
Mietubl's standard material size is 180mm (width) x 120mm (height).
You can configure your machine accord...
MTB-CUT 180T
"When cutting full-wrap back films, please disable the “Center Cut” option on the cutting page.
This is because full-wrap back films have larger dimensions,
so you can either use...
MTB-CUT 180T
"The continuous running of the motor may be caused by the following reasons:
Poor motor wiring connection: Check if the motor wiring is secure. If there is any looseness or poor co...
MTB-CUT 180T
"When cutting back films, you need to consider both the pattern position and the cutting range. You can adjust these by setting the material size and enabling or disabling center c...
MTB-CUT 180T
"The recommended cutting parameters for back films are:
Material Size: 180mm width × 120mm height
Pressure: 300
Blade Holder Scale: 5
Speed: 200
These settings are suit...
MTB-CUT 180T
"This issue is usually caused by the template being too large.
Try to disable the “Cut Center” option in the cutting page.
https://mietublweb.oss-cn-hongkong.aliyuncs.com/imag...
MTB-CUT 180T
"When the sensor malfunctions, the machine may fail to detect or automatically load the cutting material. You can try the following two approaches:
Replace the Sensor
If the senso...
MTB-CUT 180T
This issue is usually caused by a mismatch between the material size settings and the template being used.
When cutting full back film, the cutting area is larger than standard te...
MTB-CUT 180T
This issue usually occurs when the material size settings do not match the template, especially when cutting full back films.
Recommended Solution
When cutting full back film, pl...
MTB-CUT 180T
This issue usually occurs when the material size settings do not match the template, especially when cutting full back films.
Recommended Solution
When cutting full back film, pl...
MTB-CUT 180T
The Cut Centered option is used to position the cutting area exactly in the center of the material size you set.
For example, if your material size is set to 180mm (width) ×...
MTB-CUT 180T
"If the sensor is not working, please check whether it has been disabled in the settings.
Go to Settings, find the option “Material Auto-feeding”, and make sure it is turned ON....
Showing 1
to 13
of 13 results
Previous
Next
