There are three possible causes for this error: 1. The template width exceeds the maximum supported size The maximum cutting width of the screen protector machine is 228 mm. If...
"If the cutting process cannot start, please follow these steps to troubleshoot: Restart the machine: Power off and then restart the device. Check carriage reset: When the machi...
Error 1002 indicates that a device port is occupied. In this case, you can try the following steps: Restart the device and go to "My" → "About This Device" to check if the Q...
"A knocking sound from the machine can be caused by the following reasons and can be resolved as follows: Transport screws not removed (for new machines) New machines are shippe...
"If your machine stays in the “Status Checking” state for a long time, it may be caused by network delays or communication errors. Please try the following steps: Restart the machi...
"If the 180T screen protector cutting machine displays a “Reconnection” message after startup, it is likely that there is an issue with the system firmware. You can resolve this by...
"If the machine displays a “connection timeout” message during startup, it typically indicates a mainboard failure. Please contact your local distributor to obtain a replacement ma...
1. Check whether the Wi-Fi module is working Open the Wi-Fi list page on your machine and confirm: Whether the machine can scan and display the Wi-Fi networks around you; Whethe...
This issue is usually caused by unstable network connection or software malfunction, which prevents the device from retrieving user data. Please check whether the device is proper...
The correct Gear Ratio settings are: X-axis: 2000 Y-axis: 2000 Please do NOT modify the Gear Ratio settings. Incorrect Gear Ratio values may cause the machine to malfun...
"By default, the Mietubl screen protector cutting machine does not support direct PC connection. The machine runs on an independent embedded operating system, and all templates and...
"By default, the Mietubl screen protector cutting machine does not support direct PC or laptop connection. The machine runs on an independent embedded operating system, and all tem...
"If the cutting Car fails to stop properly when reaching the edge and produces a loud noise, it is likely due to an error in the Car’s limit positioning. You can replace specific p...
"If the MTB-CUT M288 intelligent film cutting and pasting machine fails to automatically secure the screen protector or if the vacuum pump does not start, it may indicate a vacuum...
"If the MTB-CUT M288 intelligent film cutting and pasting machine fails to automatically secure the screen protector or if the vacuum pump does not start, it may indicate a vacuum...
If the MTB-CUT M288 triggers an alarm during the installation process—especially when installing on iPhone models—please don't worry. This happens because the silicone...
"Error 1002 indicates a serial communication error within the machine. If you encounter this issue, please try the following steps: Reconnect to Wi-Fi and restart the device...
"If the machine is continuously beeping and not working properly, please try the following steps: Force Restart: Press and hold the power button for 20 seconds to force the machine...
"English Version If you notice white edges when applying a screen protector using the MTB-CUT M288, the issue may be caused by the following reasons: Template too large It’s re...
"To update the firmware on the M288 for fixing issues like UV film white edges, follow these steps carefully: Connect to a stable network Ensure the M288 is connected to a reliabl...
