When the machine beeps with a repeated “bip bip” sound and fails to start cutting, it usually means that the X-axis or Y-axis cannot operate normally. Common causes include a stuc...
There are three possible causes for this error: 1. The template width exceeds the maximum supported size The maximum cutting width of the screen protector machine is 228 mm. If...
If the machine displays a “Time Out” error during film cutting, please follow the steps below: 1. Check whether the motherboard is connected On the machine, go to:...
"The MTB-CUT M288 uses an integrated clip-on screen design. If you need to replace the screen, simply use a tool to release the clips and connect the new screen to the power cable....
Error 1002 indicates that a device port is occupied. In this case, you can try the following steps: Restart the device and go to "My" → "About This Device" to check if the Q...
"If your machine stays in the “Status Checking” state for a long time, it may be caused by network delays or communication errors. Please try the following steps: Restart the machi...
"If the 180T screen protector cutting machine displays a “Reconnection” message after startup, it is likely that there is an issue with the system firmware. You can resolve this by...
"If the machine displays a “connection timeout” message during startup, it typically indicates a mainboard failure. Please contact your local distributor to obtain a replacement ma...
1. Check whether the Wi-Fi module is working Open the Wi-Fi list page on your machine and confirm: Whether the machine can scan and display the Wi-Fi networks around you; Whethe...
Please first confirm the specific issue you are facing: 1. If the blade holder does not go down during cutting This is usually caused by a mainboard malfunction. In this case, t...
"Error 1002 indicates a serial communication error within the machine. If you encounter this issue, please try the following steps: Reconnect to Wi-Fi and restart the device...
"If the cutting process cannot start, please follow these steps to troubleshoot: Restart the machine: Power off and then restart the device. Check carriage reset: When the machi...
"If the machine is continuously beeping and not working properly, please try the following steps: Force Restart: Press and hold the power button for 20 seconds to force the machine...
"English Version If you notice white edges when applying a screen protector using the MTB-CUT M288, the issue may be caused by the following reasons: Template too large It’s re...
"To update the firmware on the M288 for fixing issues like UV film white edges, follow these steps carefully: Connect to a stable network Ensure the M288 is connected to a reliabl...
If the device shows an error such as “Failed to query the hardware version”, please try the following steps: 1.Restart the machine and check if the message disappears....
