If the machine is operating slowly, it is usually because the cutting speed is set too low. You can adjust the setting by following these steps: Open the Settings page; Find the...
"The cutting machine may work slowly if the cutting speed setting is too low. Please try setting the cutting speed to the default value of 200 and then attempt cutting again. If...
"A slow APP startup is usually caused by excessive cached data slowing down performance. You can try the following steps: Clear the Cache: Follow the steps shown in the video to go...
You can find the machine’s serial number from two locations: 1. On the back of the machine There is a physical sticker on the back of the screen protector machine that cont...
If the machine displays a “Time Out” error during film cutting, please follow the steps below: 1. Check whether the motherboard is connected On the machine, go to:...
If the machine is vibrating abnormally, please check the following two points: 1. Check the transportation screw If this is a new machine, please make sure the screw on the back...
"When the sensor malfunctions, the machine may fail to detect or automatically load the cutting material. You can try the following two approaches: Replace the Sensor If the senso...
There are three possible causes for this error: 1. The template width exceeds the maximum supported size The maximum cutting width of the screen protector machine is 228 mm. If...
If the machine displays “K_data_update_error”, it is usually because the APP data loading process was interrupted after an upgrade, resulting in incomplete data. Please try the fo...
Please open the machine’s WiFi list and check whether available WiFi networks can be detected normally. If the machine cannot detect or display WiFi networks, the machine’s networ...
If the machine displays “Device is Disabled” while you are using it, please first check whether the machine is connected to the internet. If the machine is already onl...
There are three possible causes for this error: 1. The template width exceeds the maximum supported size The maximum cutting width of the screen protector machine is 228 mm. If...
If the machine is showing “Failed to query the hardware version of the machine”, the machine’s mainboard may be faulty. In this case, the mainboard may...
If your MTB-CUT M188 displays a “Time Out” or “Reconnection” error after startup, please follow the steps below: Step 1: Check the machine barcode Check t...
"First, please check the barcode on the back of your machine: For devices with a barcode format MT00XXXXXXXXXXX, the machine supports connection to Canon G580 / G680 and Epson L325...
"A knocking sound from the machine can be caused by the following reasons and can be resolved as follows: Transport screws not removed (for new machines) New machines are shippe...
"If your machine stays in the “Status Checking” state for a long time, it may be caused by network delays or communication errors. Please try the following steps: Restart the machi...
Using the machine is very simple. After completing the account registration, you only need to: Select the required phone model/template on the machine Place the cutting materi...
The MTB-CUT 180TPro screen protector cutting machine supports: Canon printers Epson printers When connecting the printer, please make sure: The printer and the screen prote...
"If the machine is continuously beeping and not working properly, please try the following steps: Force Restart: Press and hold the power button for 20 seconds to force the machine...
